Coreldraw x5 is unresponsive with windows 10

#Coreldraw x5 is unresponsive with windows 10 drivers
#Coreldraw x5 is unresponsive with windows 10 update
#Coreldraw x5 is unresponsive with windows 10 manual

Please make sure to update CorelDRAW to version X7.4 or later before use.

In Corel DRAW 2018 or later, is not available if a symmetry object (drawn in Symmetry mode > ) is included in the data. The cutting conditions specified by this software will not be effective unless setting is changed on the operation panel of cutting plotter when using the following models. If X4 or earlier version is installed, it cannot open the Registration Mark menu. When using the 64-bit edition of CorelDraw X 6 or later, CorelDraw X4 or earlier can not be installed on the PC. (It also might occur when opening files created with Illustrator CC2017 or earlier in later versions.) Since it does not affect your data, you can print or cut it properly. When placing Segmented Registration Marks (horizontal) in Illustrator version after CC2018, the middle mark might be displayed as figure on the right. The firmware needs to be the follwong version. (*2)Notice for using the Illustrator CS6 and later editions. (*1)On software, it is run in the WOW64 mode (32-bit emulation mode) when the 64-bits Windows OS is used. * Data Link cannot be used with the port created when installing OPS662.

#Coreldraw x5 is unresponsive with windows 10 drivers

* It cannot be used on the port created by other drivers (e.g. (2) When using LAN (network) connection: 'Add device settings' > 'TCP / IP'

(1) When using USB connection: 'Add device settings' > 'Graphtec USB' *In case of using Data Link in Cutting Master 4/Graphtec Pro Studio, select and use the following two patterns depending on the connection method. *Administrator permission will be required. The Cutting Master 3 / Graphtec Studio needs to be closed before the Cutting Master 4 is started. The Cutting Master 4 and the Cutting Master 3 / Graphtec Studio cannot be used simultaneously.

#Coreldraw x5 is unresponsive with windows 10 manual

(*3) The cutting conditions specified by this software will not be effective unless setting is changed on the operation panel of cutting plotter when using the following models.Д¬hange the setting of CONDITION PRIORITY from MANUAL to PROGRAM in the TOOLS SETTING menu.Д¬hange the setting of PRIORITY from the MANUAL to COMD in the special function setting menu. (*2) The firmware needs to be the following version. Please re-save the data file in a format other than the Illustrator 9 using the Illustrator CS5 or older edition before opens the data file by the Illustrator CS6 and later editions.

Please re-save the data file to Illustrator 8 format in the Illustrator 9 before opens the data file by the Illustrator CS6 and later editions. It occurs when the illustrator 9 format data is opened by the Illustrator CS6 and later editions. It is issue of the Illustrator CS6 and later editions. The cause of this phenomenon is not the Cutting Master 4. The Cutting Master 4 cannot to recognize registration mark because the name of layer for the registration mark is also changed. When the data file in the Illustrator 9 format is opened using the Illustrator CS6 and later editions, the name of all layers are changed to 'layers'. Notice for using the Illustrator CS6 and later editions. (*1) PC system needs to fit system requirements for Adobe Illustrator. (*) Cutting Master 4 and Cutting Master 3 / Graphtec Studio cannot be used simultaneously.Д¬utting Master 3 / Graphtec Studio needs to be closed before tCutting Master 4 is started.